hello, i will try and post some progress updates on the 216 as i go. first job was sorting the bonnet release mechanism, it wasnt closing correctly and took a lot of force to get it to latch. a good cleanput and re adjustment heped somewhat, but can anyone conform
if the support bar should be totally verticle? as i think it might have had a little knock thus moving the latch unit down a bit
Just a tip with the bumper strip glue - superglue isn't waterproof. You'll need to use Araldite 2-part epoxy or Gorilla glue (which is water-activated) if you want a permanent fix. If you use either of these, getting the glue off for the proper fix may cause you some problems, so use sparingly. The other option is to use GT Pro tape - double-sided foam tape with very sticky acrylic adhesive. Does eventually rub off with your fingers if you need to remove it - but it's hard work.